Home PageAbout UsAlmen GaugeAlmen StripsMagna ValvesNON-Ferrous MagnaValves Hopper RefillShotShape ClassifiersShockformContact Us
Craftlast Ltd
UK representative for Electronics Inc and Shockform Inc
Almen Gauge

We supply the TSP-3B Almen gauge, the best there is, also the TSP-JR (inch or m/m) probably the second best. We also supply the Almen Holder Flatness Gauge

The TSP-3B Aerospace Inspection Grade Almen Gauge meets all current specifications up to and including SAE J442, AMS 2430 & AMS 2432C. Every gauge is supplied in a sturdy, protective foam lined case with a certificate of calibration.

Patented precision magnetic support balls and foolproof end stops provide hands free,repeatable Almen strip alignment and measurement whilst completely eliminating any possible distortion.

SPC data port is standard on this gauge allowing direct data transfer to your computer via a USB interface device available as an accessory.

TSP-JR Almen Gauge. This is a more industrial gauge and is available with either digital or analogue dial.

It smaller size and lighter weight make it a more convenient gauge for shop floor use.

When supplied with a digital dial the gauge meets the requirement of SAE J442. When supplied with an analogue dial it meets the requirements of MIL-S-13165. The analogue gauge can be specified with either an Imperial or Metric dial. The gauge is supplied in a protective case with appropriate certification.

 

Almen Holder Flatness Gauge

In-Situ flatness check
SAE J442
Satisfies Nadcap Audit
Fast and easy to use

How do you verify flatness of your Almen holder that is rigidly attached to a fixture? It's easy when you have the special Holder Flatness Gauge. This simple two piece design allows you to verify flatness in almost any orientation. Attach the special frame with the (supplied) screws and traverse the indicator over the surface. The dial indicator is graduated 0.01mm flatness limit of +/- 0.1mm

The screw holes in the frame are designed to verify the accuracy of the holder's screw locations(another nadcap requirement). The frame holes are oblong to recognise the placement and tolerances of the holes in the holder.

This gauge will confirm Almen holder compliance with the flatness requirements of SAE J442 specification.

(Inch version available upon request)

- 0 -

Aluminium strips are also available.

We supply certified, fully hardened, Almen strip holder blocks with a choice of tapped (M5) or plain holes plus boxes containing 100  M5 screws to suit the tapped blocks.

Almen Holder Flatness Gauge

 

 

Home PageAbout UsAlmen GaugeAlmen StripsMagna ValvesNON-Ferrous MagnaValves Hopper RefillShotShape ClassifiersShockformContact Us
All Rights Reserved...